Maytag Atlantis Washer Manual Remove Agitator Kenmore

Repair

THE DIFFERENCE BETWEEN AGITATOR VS. IMPELLER WASHERSAgitators and impellers are both found in top loading washing machines, but they clean in two different ways. So what’s the main difference between agitators vs. Impellers?Washing machines with agitators use a central post that twists back and forth, rubbing against clothes to help break apart stains. In contrast, washing machines with impellers use a low-profile cone or disc that spins/rotates to rub clothes against each other to get them clean.View this side-by-side comparison to learn how washing machines with impellers stack up against washing machines with agitators.

I have an older Maytag top load washer (model LAT9206BAE). Not sure how old it is. We moved here 3 years ago, and it came with the house.

Whirlpool Washer Agitator Removal

Atlantis

It recently began making some slight noises during the wash cycle. I guess you can call it a slight squeaking noise. The agitator does turn, but it doesn't seem like it's turning as well as it should during the wash cycle. Everything spins as it should during the spin cycle.

Zentangle basics pdf

From what I can tell, the belts look like they're turning ok. I took the front cover off and looked under the bottom the best I could. I've seen something online about replacing the agitator dogs. Does anyone have any insight as to what may be the problem?

Maytag Washer Manual

Do the agitator dogs wear out over time? Does anyone think I may need new belts?Thanks. On your model washer the dogs can't be replaced. You'll need to replace the agitator.

Maytag Atlantis Washer Problems

The agitator is a two piece design. The bottom part of the agitator moves back and forth. The top part of the agitator turns in one direction only.

Start the machine on a normal wash cycle and see if the bottom part of the agitator is moving correctly. If it is then replace the agitator. If not, make sure the motor moves freely on the motor mounting plate. With the front panel off, push the motor towards the back of the machine then release it and the springs in the motor mounting plate should pull it back. If the motor moves OK, replace the belts.